RedMax EBZ3050RH Manuel de l'opérateur télécharger pdf (Page 11)

US-11

EBZ3050RH

U

S

8. Operation

■ STARTING ENGINE

• Avoid operating the blower with the

flexible tube and swivel joint

disconnected. That will reduce the

cooling air and the engine could be

damaged by overheating.

1. Push the primer bulb until fuel flows out

in the clear tube. (F6)

(1) Primer Bulb

2. When the engine is cool, close the

choke. (F7)

(1) Choke Lever

(2) CLOSE

(3) OPEN

3. Set the ignition switch to the start

position. (F8)

4. Set the throttle lever in idling position.

(F8)

(1) Full Throttle

(2) Idling

(3) Ignition Switch

5. To start, hold the top of the blower

firmly and hold the flame by your foot.

Pull the starter knob slowly until you

feel it engage and then give it a

vigorous strong pull. (F9)

•Avoid pulling the starter rope out to

its full extent and allowing the

starter rope to snap back. This will

prevent premature damage to the

starter.

• Do not let a person stand near the

blower or the exhaust port.

• Never to touch the muffler, spark

plug, other metallic parts of the

engine or engine cover while the

engine is in operation or

immediately after shutting down the

engine. These metallic parts and

IMPORTANT

IMPORTANT

F6

F9

(1)

F10

(1)

(2)

(3)

F8

F7

engine cover reach high

temperatures during operation and

doing so could result in serious

burns.

6. Once the engine is running, gradually

open the choke if it was set closed, and

let the engine run at idle speed for a

minute to warm it up.

When the engine fails to start after

several attempts due to overchoking,

open the choke and repeat pulling the

rope.

■ ADJUSTING IDLE SPEED (F10)

• The idling speed is set for 3000 rpm at

the factory. If it is necessary to adjust

the idle speed, use the adjustment

screw on the top side of carburetor.

(1) Idling Adjustment Screw

■ STOPPING ENGINE

•Move the throttle lever to the idling

position and set the ignition switch to

the stop position. (F11)

(1) Ignition Switch

If the engine won’t stop when setting

the ignition switch to the stop position,

close the choke lever and stop the

engine.

In this case, please repair the machine

at your nealest servicing dealer. (F12)

(1) Choke Lever

(2) CLOSE

(3) OPEN

NOTE

NOTE

(1)

F11

F12

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire