RedMax G3100T Spécifications télécharger pdf (Page 10)

 10 

■ FUELING THE UNIT (OP1)

1. Remove the fuel tank cap and pour fuel into the

tank up to 80% of full capacity.

2. Fasten the fuel cap securely and wipe up any

fuel spillage around the unit.

3. Remove the oil tank cap and pour chain oil into

the tank. Fasten the cap securely.

1. Select bare ground for fueling.

2. Move at least 10 feet (3 meters) away from the

fueling point before starting the engine.

3. Stop the engine before refueling the unit.

It is very dangerous to run a chainsaw that

mounts broken parts or lacks any parts.

Before starting engine, make sure that all the

parts including bar and chain are installed

properly.

■ STARTING ENGINE

Keep clear of the saw chain as it will start

rotating upon starting of the engine.

1. Continuously push the priming bulb until fuel

comes in the bulb. (OP2)

2. Put the ignition switch to “ I ” position. (OP2)

3. While holding the throttle lever together with the

throttle interlock, push in the side button and

release the throttle lever to hold it at the start

position. (OP3)

4. Pull out the choke knob to the closed position.

(OP4)

When restarting immediately after stopping the

engine, Ieave the choke knob at the open position.

NOTE

WARNING

7. Operation

OP1

OP2

OP3

OP4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

RedMax G3100T Spécifications Page 10