RedMax G3800AVS Spécifications télécharger pdf (Page 12)

 12 

It is very dangerous to run a chainsaw that

mounts broken parts or lacks any parts.

Before starting engine, make sure that all the

parts including bar and chain are installed

properly.

■ STARTING ENGINE

1. Fill fuel and chain oil tanks respectively, and

tighten the caps securely. (F7)

2. Put the switch to "I" position. (F8)

(1) Chain oil (2) Fuel (3) Switch

(4) Throttle lever (5) Throttle interlock

3. Pull out the choke knob to the second-stage

position. The choke will close and the throttle

lever will then be set in the starting position

[F10-(a)].

(6) Choke knob

When restarting immediately after stopping the

engin, Choke knob in the first-stage position (choke

open and throttle lever in the starting position)

Once the choke knob has been pulled out, it will

not return to the operating position even if you

press down on it with your finger. When you wish

to return the choke knob to the operating position,

pull out the throttle lever instead.

4. While holding the saw unit securely on the

ground, pull the starter rope vigorously. (F11)

Do not start the engine while hanging the chain

saw with a hand. The saw chain may touch

your body. It's very dangerous.

5. When engine has ignited first, puch in the choke

knob to the first-stage position and pull the

starter again to start the engine.

6. Allow the engine to warm up with the throttle

lever pulled slightly.

WARNING

NOTE

WARNING

7. Operation

F10

F11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

RedMax G3800AVS Spécifications Page 12