RedMax GZ4500 Manuel de l'opérateur télécharger pdf (Page 5)

US-5

GZ4500

1. Never operate a chain saw when you are

fatigued, ill, or upset, or under the

influence of medication that may make

you drowsy, or if you are under the

influence of alcohol or drugs.

2. Use safety footwear, snug fitting clothing

and eye, hearing and head protection

devices.

Use the vibration-proof glove.

3. Keep the saw chain sharp and the saw,

including the AV system, well maintained.

A dull chain will increase cutting time, and

pressing a dull chain through wood will

increase the vibrations transmitted to your

hands. A saw with loose components or

with damaged or worn AV buffers will also

tend to have higher vibration levels.

4. All the above mentioned precautions do

not guarantee that you will not sustain

whitefinger disease or carpal tunnel

syndrome. Therefore, continual and

regular users should monitor closely the

condition of their hands and fingers.

If any of the above symptoms appear,

seek medical advice immediately.

5. Always use caution when handling fuel.

Wipe up all spills and then move the chain

saw at least 3 m from the fueling point

before starting the engine.

6. Eliminate all sources of sparks or flame

(i.e. smoking, open flames, or work that

can cause sparks) in the areas where fuel

is mixed, poured, or stored.

7. Do not smoke while handling fuel or while

operating the chain saw.

8. Do not allow other persons to be near the

chain saw when starting or cutting. Keep

bystanders and animals out of the work

area. Children, pets and bystanders

should be a minimum of 10 m away when

you start or operate the chain saw.

9. Never start cutting until you have a clear

work area, secure footing, and a planned

retreat path from the falling tree.

10. Always hold the chain saw firmly with both

hands when the engine is running. Use a

firm grip with thumb and fingers encircling

the chain saw handles.

5. For safe operation

11. Keep all parts of your body away from the

saw chain when the engine is running.

12. Before you start the engine, make sure

the saw chain is not contacting anything.

13. Always carry the chain saw with the

engine stopped, the guide bar and saw

chain to the rear, and the muffler away

from your body.

14. Always inspect the chain saw before each

use for worn, Ioose, or damaged parts.

Never operate a chain saw that is

damaged, improperly adjusted, or is not

completely and securely assembled. Be

sure that the saw chain stops moving

when the throttle control trigger is

released.

15. All chain saw service, other than the items

listed in the Owner’s Manual, should be

performed by competent chain saw

service personnel. (E.g., if improper tools

are used to remove the flywheel, or if an

improper tool is used to hold the flywheel

in order to remove the clutch, structural

damage to the flywheel could occur which

could subsequently cause the flywheel to

disintegrate.)

16. Always shut off the engine before setting

it down.

17. Use extreme caution when cutting small

size brush and saplings because slender

material may catch the saw chain and be

whipped toward you or pull you off

balance.

18. When cutting a limb that is under tension,

be alert for spring- back so that you will

not be struck when the tension in the

wood fibers is released.

19. Never cut in high wind, bad weather,

when visibility is poor or in very high or

low temperatures. Always check the tree

for dead branches which could fall during

the felling operation.

20. Keep the handles dry, clean and free of

oil or fuel mixture.

21. Operate the chain saw only in well

ventilated areas. Never start or run the

engine inside a closed room or building.

Exhaust fumes contain dangerous carbon

monoxide.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

RedMax GZ4500 Manuel de l'opérateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne RedMax GZ4500