RedMax PSZ2500 Spécifications télécharger pdf (Page 15)

■ MOUNTING ENGINE (SE1)

1. Push the driveshaft housing toward the clutch

housing and rotate it by hand to check that the

driveshaft is engaged with the gears.

2. Insert the driveshaft housing into the clutch

housing until it bottoms, and align the positioning

holes on the clutch housing and the shaft tube

and install the screw. When difficult to engage,

twist the engine slightly.

3. Fasten the clamp securely with two screws.

Tighten the screws gradually by turns.

■ CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint

on the top of the carburetor. (SE2)

■ CONNECTING SWITCH WIRES

• Connect the switch wires between the engine

and the main unit. Pair the wires of the same

color.

■

ATTACHING THE PRUNING MECHANISM (SE3)

1. Remove the cap on the end of the main pipe.

2. Remove the screw screwed into the end of the

gear case.

3. Insert the end of the gear case into the main

pipe.

4. Line up the hole on the end of the gear case into

which the screw is to be inserted with the hole

on the main pipe, and screw the screw firmly in.

5. Using a wrench, screw in the bolt provided to fix

the mechanism into place.

(1) Main pipe

(2) Gear case

(3) Screw hole

(4) Fastening bolt

(5) Bolt

IMPORTANT

6. Set up

❲

❳

SE1

SE2

(1)

(2)

(3)

(4)

(5)

SE3

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

RedMax PSZ2500 Spécifications Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne RedMax PSZ2500