Redmax SGCZ2401S Manuel d'utilisateur télécharger pdf (Page 30)

8. Operation

English

■ STOPPING ENGINE (OP3)

1. Release the throttle lever and run the engine for a

half minute.

2. Shift the ignition switch to the STOP position.

• Except for an emergency, avoid stopping the engine

while pulling the throttle lever.

■ ADJUSTING THROTTLE CABLE

• The normal play is 1 or 2mm when measured at the

carburetor side end. Readjust with the cable adjuster

as required. (OP5)

(1) cable adjuster

■ ADJUSTING IDLING SPEED (OP6)

1. When the engine tends stop frequently at idling

mode, turn the adjusting screw clockwise.

2. When the cutting head keeps rotating after releasing

the trigger, turn the adjusting screw counter-

clockwise.

(1) idle adjusting screw

• Warm up the engine before adjusting the idling

speed.

■ USAGE

This machine does cutting not by a rotary cutter like

conventional trimmers but by a pair of special blades,

each upper blade and lower blade oscillate opposite

direction alternately within a limited angle at a speed of

approximately 1/30 of conventional trimmers.

This unique mechanism brings you many benefits like

the following:

1. Since the blade does not cause grass chips and

pebbles to the thrown around, you may use less

care about your clothing or surroundings.

2. Should the blade hit a rigid object like stones, trees

or steel poles during operation, it does not produce a

bounce motion that can cause loss of machine

control.

3. Since the blade does not cause cut grass to wrap

around the neck, you need not to stop operation to

remove such wrappers.

NOTE

IMPORTANT

(1)

OP6

.04 in

(1~2mm)

(1)

OP5

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Redmax SGCZ2401S Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Redmax SGCZ2401S