Redmax GZ4000 Manuel d'utilisateur télécharger pdf (Page 10)

US-10

GZ4000

8. Operation

It is very dangerous to run a chainsaw

that mounts broken parts or lacks any

parts.

Before starting engine, make sure that

all the parts including bar and chain

are installed properly.

■ STARTING THE ENGINE

1. Fill fuel and chain oil tanks

respectively, and tighten the caps

securely. (F7)

2. Set the switch to “I” position. (F8)

(1) Chain oil

(2) Fuel

(3) Switch

(4) Throttle lever

(5) Throttle interlock

3. Pull out the choke knob to the second-

stage position. The choke will close

and the throttle lever will then be set in

the starting position [F10-(a)].

(6) Choke knob

When restarting immediately after

stopping the engine, set the Choke knob

in the first-stage position (choke open and

throttle lever in the starting position).

Once the choke knob has been pulled

out, it will not return to the operating

position even if you press down on it with

your finger. When you wish to return the

choke knob to the operating position, pull

out the throttle lever instead.

NOTE

NOTE

WARNING

F8

F7

F12

F9

F10

F11

4. While holding the saw unit securely on

the ground, pull the starter rope

vigorously. (F11)

Do not start the engine while the chain

saw hangs in one hand. The saw chain

may touch your body. This in very

dangerous.

5. When engine has ignited, first push in

the choke knob to the first-stage

position and then pull the starter again

to start the engine.

6. Allow the engine to warm up with the

throttle lever pulled slightly.

Keep clear of the saw chain as it will

start rotatIng upon starting of engine.

■ CHECKING THE OIL SUPPLY

Make sure to set up the bar and the

chain when checking the oil supply.

If not, the rotating parts may be

exposed. It is very dangerous.

After starting the engine, run the chain at

medium speed and see if chain oil is

scattered off as shown in the figure. (F12)

(1) Chain oil

The oil tank should become nearly empty

by the time fuel is used up. Be sure to

refill the oil tank every time when refueling

the saw.

NOTE

WARNING

WARNING

WARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire